Move the choke lever to the FULL position. Press the trigger throttle and pull the starter cord until the engine attempts to start, but no more than five times to prevent flooding the engine. Hold the throttle down for an additional 10 seconds, then move the choke lever to the RUN position. Locate the idle speed screw on the back of the engine cover in the upper right corner.
Insert a screwdriver into the hole in the cover to access the idle speed screw. Turn the idle speed screw clockwise if the engine will not idle properly or dies when the trigger throttle is released.
Discussion is closed. Question: Fuel Lines Replaced dickalban It will now start but will cut out shortly after I get it started. Seems it is now not getting fuel. Hi dickalban44 If the machine is not new, and the OLD fuel lines were deteriorated,some debris from them may have entered the carburetor. Remove the carb and then remove the fuel pump cover on it.
That is the cover on the top without the vent hole. Inside the carb body is a circular, very fine mesh screen. You will find it once you remove the cover gasket and fuel pump diaphragm.
It will need to be cleaned. Spray it liberally with WD until you can see the gray screen is clear. It is very small, but it is there. Try that and post back for more help. I hope you replaced the fuel filter inside the fuel tank. Question: Fuel Return Line Part : What holds the fuel return line to the fuel tank.
Is it simply pushed through the hole in the fuel tank or is there some sort of washer like the fuel line and filter Part : has on the gas tank end?
Hi Sometimes, the factory installation includes a small nipple on the end of it inside the tank, so that it cannot be accidentally removed. Since you know it is there, just insert it an inch or so into the tank and it will be fine.
Question: Check For Spark fla2az2tn. Read through this article and it should show you the steps on how to test for a spark. If you don't have a spark plug tester as shown. You should be able to pick one up at a local automotive supply store. Hope this helps, -WJA.
Question: Primer sabre I just replaced the fuel tank on a Ryobi cultivator, however the tank 2 fuel lines one going to the carb and one going to the primer so where does the third fuel line go. Hello sabre23, We have an article and video regarding this subject. Here is the link to it. Question: Ryobi r Blklab Are all Fuel tanks the same on ryobi r, can't find anyother on it. Hello Blklab56, The fuel tank for all of the Ryobi R Tillers is the same it is part number Sign up.
Wrap the throttle wire once around the handlebar Fig. Depress the throttle trigger and locate hole for the throttle wire Fig. With the throttle trigger depressed, place the barrel end of the throttle wire inside the hole of the trigger Fig.
Be in the starting position when pulling the starter rope Fig. The operator and unit must be in a stable position while starting to avoid serious personal injury. Page Operating Instructions Do not wear short pants, sandals or go barefoot. Move the cultivator to the work area prior to starting the engine. The cultivator may be transported by pushing it on wheels or carrying it by the shaft tube grip. It is important that the tines are installed correctly. Clean and re-oil the air filter every 10 hours of operation.
It is an important item to maintain. NOTE: Careless adjustments can seriously damage your unit. An authorized service dealer should make carburetor adjustments. Page Specifications Fuel Tank Warranty services or repairs will be provided at all Authorized Ryobi Service Centers. Print page 1 Print document 22 pages. Rename the bookmark.
0コメント