If vases, shall be placed on the apparatus. Protect the power cord from being walked on or for ventilation to ensure reliable operation of the pinched particularly at plugs, convenience receptacles, CAMCORDER and to protect it from overheating. These openings must not be blocked or covered. If you are grounding of the lead-in wire and supporting structure, not sure of the type of power supply at your home, grounding of the mast and supporting structure, consult your appliance dealer or local power company.
When the power-supply cord or plug is damaged. An outside antenna system should not be located in b. When installing an outside antenna water.
If the CAMCORDER does not operate normally touching such power lines or circuits as contact with by following the operating instructions, adjust only them might be fatal. Improper adjustment of other controls Do not overload wall outlets and extension cords as may result in damage and will often require this can result in a risk of fire or electric shock.
Should spillage occur, unplug unit When replacement parts are required, be sure the service technician has used replacement parts Unauthorized Opening or removing covers may expose you to substitutions may result in fire, electric shock or other dangerous voltage or other hazards.
Refer all servicing hazards. To prevent damage which may result in fire or shock NOTE: This equipment has been tested and found to comply hazard, do not expose this appliance to rain or with the limits for a Class B digital device, pursuant to part 15 moisture. If this power supply is used at V ac, a suitable plug These limits are designed to provide reasonable protection adaptor should be used.
This product is covered by one or more of the following This equipment generates, uses and can radiate radio U. However, there is no guarantee that 6,, 6,, 6,, 6,, 6,, interference will not occur in a particular installation. For details see FCC Warning lamprecycle. Caution Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type. If this power supply is used at V ac, a suitable plug adaptor should be used. Play back your trial recording to make sure the video and audio have been recorded properly. Samsung cannot be responsible for your recorded video and audio. Samsung shall not be responsible for compensation for damages due to the loss of recorded contents.
Protect your important recorded data by copying the files to PC. We also recommend you copy it from your PC to other recording media for storage. Refer to the software installation and USB connection guide.
Even if you record an event such as a show, performance or exhibition for personal enjoyment, it is strongly recommended that you obtain permission beforehand. Although the external appearance is different, they operate in the same way.
Refer to the marks to the right of each function to identify whether the memory card or disc is compatible with the function. Refer to these marks and identify the functions and operation to match the memory card or disc you use. All rights reserved. If unevenness does not disappear, turn the camcorder off, wait for a few moments, then turn it on again. Normal brightness will be restored when the temperature inside the camcorder rises.
This has no effect on the images in the storage media, so there is no cause for concern. Take great care that you do not strike it against a hard object or let it fall. Fine sand or dust entering the DVD camcorder or AC power adaptor could cause malfunctions or defects. Water or oil entering the DVD camcorder or AC power adaptor could cause electric shock, malfunctions or defects.
During playback of normally recorded video and audio, noise may also be present in picture and sound. At worst, the DVD camcorder could malfunction. Turn the DVD camcorder off and cover it with vinyl sheet, etc. If you touch the lens in the laser pickup block directly it may cause a malfunction. The laser pickup block is not warranted for damage caused by misuse.
Therefore, pay much attention when operating this camcorder. See the reference pages below for more information. DVD discs do not support photo mode.
When recording movie images on a DVD disc Select the proper disc for use. Do you want to delete or edit movie images on the DVD camcorder? DL played on most DVD devices. If you do not use them, recording and playback operation may not work properly or you may not be able to eject the disc from the camcorder.
If needed, unfinalize the disc. Remove the battery cover. Insert the button-type battery then place the battery cover back. Battery release switch Battery installation for the internal clock The button type battery maintains the clock function and preset contents of the memory : even if the battery pack or AC power adapter is removed.
Installing the button-type battery in the remote control SC-DX only 1. The battery holder opens. Battery 3. This will cause a short circuit. Keep the button type battery out of the reach of the children. Pull and detach the grip belt. Insert the grip belt into its hook as shown in the figure.
Insert your hand into the grip belt and adjust its length. Close the grip belt. Angle Adjustment Rotate the swivel handle to the most convenient angle. Please be careful not to turn the swivel handle backward as it may cause damage. To charge the battery pack Be sure to charge the battery pack before you start using your DVD camcorder. Attaching the battery pack to the DVD camcorder 1. Open up the LCD screen 90 degrees with your finger. Fit the battery pack to the battery attachment platform and push the battery pack as shown in the figure until a click is heard.
Removing the battery pack from the DVD camcorder 1. Slide the BATT. Insert the battery pack in the accurate direction as shown in the figure. Do not use batteries from other manufacturers. Otherwise, there is a danger of overheating, fire or explosion. Samsung is not responsible for problems occurring due to using unapproved batteries. If this happens, place the battery pack in your pocket or other warm, protected place for a short time, then re-insert it to the DVD camcorder.
It may cause leakage, heat generation, induce overheating or fire. As the environmental temperature and conditions vary, the remaining battery time may differ from the approximate continuous recording times given in the instructions. When the battery reaches the end of its life, please contact your local dealer. The batteries have to be treated as chemical waste. The battery pack may be prone to leakage when fully discharged.
Even when the power is switched off, the battery pack will still discharge if it is left attached to the DVD camcorder. If no operation is made for 3 more minutes while the unit is sleep mode, the camcorder turns off automatically.
However, if any operation is made, the DVD camcorder comes out of sleep mode. Do not drop the battery pack as it may cause damage. About the battery life Battery capacity decreases over time and through repeated use. If decreased usage time between charges becomes significant, it is probably time to replace it with a new one. Connect the AC power adaptor to a wall socket.
It is recommended that you remove the battery pack from the DVD camcorder. Charging, recording and playback times with a fully charged battery pack with no zoom operation, etc. Continuous recording time without zoom The times shown in the table reflect the available recording time when the DVD camcorder is in the recording mode without using any other functions. Note that the battery pack discharges faster in a cold environment. Using other AC power adaptors could cause electric shock or result in fire.
An AC plug adaptor is required in some foreign countries. If you need one, purchase it at your local Samsung dealer. Disconnect the AC power adaptor from the wall outlet immediately if any malfunction occurs while using your DVD camcorder. If the battery is low, it appears right after power on.
If the DVD camcorder has warning information, a warning message will appear. Using the Joystick, you can easily make your selection and navigate the menu. Move to a lower menu item. Move to an upper menu item. Press to select the chosen item Select. Rotate it to the best angle to record or play. The viewfinder will work when the LCD screen is closed. Adjusting the focus The focus adjustment knob of the viewfinder enables individuals with vision problems to see clearer images. Close the LCD screen.
Use the focus adjustment knob of the viewfinder to focus the picture. Viewing the sun or any strong light source through the viewfinder for a prolonged period may be harmful, or cause temporary impairment. Setting 1. Press the MENU button. Select 3. STBY [30 min] 4. Move the Joystick up or down to select the desired language, then press the Joystick.
To exit, press the MENU button. Setting the date and time Set the date and time when using this DVD camcorder for the first time. STBY [30 min] 2. It may cause a malfunction. Photos can not be recorded onto a DVD disc. Inserting a disc 1. Slide the OPEN switch in the direction of the arrow.
Gently open the cover the rest of the way by hand. Push the disc into the disc compartment until a click is heard. Gently push the disc cover to close it. Do not cut off the power supply during this time. Do not shake nor apply impact. Caution This product utilises a laser. Should spillage occur, unplug unit and have it checked by a technician before use. Page 7 To prevent damage which may result in fire or shock hazard, do not expose this appliance to rain or moisture.
If this power supply is used at V ac, a suitable plug adaptor should be used. This product is covered by one or more of the following U. Page 8 DVD camcorder or memory card. Samsung cannot be responsible for your recorded video and audio.
Samsung shall not be responsible for compensation for damages due to the loss of recorded contents. Page 9 Make a backup of important recorded data.
Protect your important recorded data by copying the files to PC. We also recommend you copy it from your PC to other recording media for storage. Refer to the software installation and USB connection guide. If you push the LCD surface, unevenness in display may occur. If unevenness does not disappear, turn the camcorder off, wait for a few moments, then turn it on again.
If you touch the lens in the laser pickup block directly it may cause a malfunction. The laser pickup block is not warranted for damage caused by misuse.
Therefore, pay much attention when operating this camcorder. You can take a photo only on the memory card. DVD discs do not support photo mode. When recording movie images on a DVD disc Select the proper disc for use. Page 23 This section provides information on using this DVD camcorder; such as how to use the provided accessories, how to charge the battery, how to setup the operation mode and initial setup.
Replace only with the same or equivalent type. This will cause a short circuit. Pull and detach the grip belt. Insert the grip belt into its hook as shown in the figure. Insert your hand into the grip belt and adjust its length. Close the grip belt. The battery pack may be prone to leakage when fully discharged. Even when the power is switched off, the battery pack will still discharge if it is left attached to the DVD camcorder. It is recommended that you remove the battery pack from the DVD camcorder.
Page 30 Using the DVD camcorder with the AC power adaptor It is recommended that you use the AC power adaptor to power the DVD camcorder from a household AC outlet when you perform settings on it, finalize a disc, play back, or edit images, or use it indoors.
Using the Joystick, you can easily make your selection and navigate the menu. Page Using The Lcd Screen 1. Close the LCD screen. Use the focus adjustment knob of the viewfinder to focus the picture. Viewing the sun or any strong light source through the viewfinder for a prolonged period may be harmful, or cause temporary impairment. More than 5 minutes may be required if there are a lot of movie images recorded on the disc. One is on the rear side of the camcorder and the other is on the LCD panel.
Doing so may damage the disc or the data on it. Q mode. Q mode during recording. Q operation. Page 46 The selected file fills the screen and is played automatically. Page 47 You can set the digital zoom up to x in movie mode. If you move your finger off the zoom lever, the operation sound of the Zoom lever may be also recorded. If you close the LCD screen while playing, you will not hear the sound from the speaker.
Page Deleting Images 3. Press the MENU button. Page 51 8. The file can be damaged. You want to save the original recording, but you also want to create a digest by putting your favorite scenes together. Page 56 8. When finalizing, there should be enough power in the battery. If the AC power adaptor is to be used, make sure that the jack is properly connected. A power cut during finalizing may prevent the disc from playing.
If this occurs, copy the data into your hard disk drive. When unfinalizing, there should be enough power in the battery. Be careful not to delete data by mistake. The data recorded on a disc may be damaged. Page 61 1. Page 63 Note that formatting erases all information on the memory card. If you cannot record new data, you have to purchase a new memory card. This is normal and is not a malfunction. Page Viewing Photo Images Set the slide show function for continuous display.
Press the MENU button in the single image display mode. The slide show will start from the current image. Page Protection From Accidental Erasure 3. Page 71 3. Page Menu Items Some items will not appear depending on the storage media type.
You cannot select the gray menu items. Refer to the Troubleshooting for examples of the inoperable combinations of functions and menu items. Scene Mode AE This DVD camcorder automatically sets the shutter speed and aperture according to the subject brightness for optimum recording: You can also specify one of six modes depending on conditions, recording environment or purpose of filming.
Page White Balance 1. Frame a white object such as a piece of white paper so that it fills the screen. Use an object that is not transparent. Because the color temperature is different depending on the light source, the subject tint will differ depending on the white balance settings.
0コメント